Heres my latest punt into getting figures printed out, more from a lets see what happens sort of approach...still trying to work out my modelling kinks so it works when reduced down..
Simple enough figure and im happy with the print quality, but again i think i have a few scaling issues with the smaller figures( with my sculptin)...oh its 30mm to the top of the hat...

Finh, where did you have it printed, it looks great!
Also, what sculpting application did you use, or did you have it scanned?
Is it only hallow on the base, or all the way through?

It was a place in Poland, i`ll have to dig out the address...I`ll have it someplace.....The sculpting was done in Zbrush and so no scanning involved....the figure is solid, its thats small that if it was hollow it would probably crumble away...